What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 10:26

The bolt then partially travels down the line to your home.
2024–10–14 [Omar Gharbi Omar Gharbi ]
[image of Common-mode choke]
eight
nine
One
Friday the 13th solar storm could bring auroras to 18 US states this weekend - Live Science
A fuse is a non-resetable over current circuit protector.
There are two important concepts here.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Corrupti suscipit aliquid odit totam.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Edit 2024–10.
These are simplified answers to the original question, and does not change anything I wrote above.
Can a white person wear a bonnet to bed?
At one ohm, the resistor has a maximum of 1 watt power.
For this case there are devices called Metal oxide varistors (MOV).
I post the exact comment here.
But it can get overloaded, and no longer works.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
LIVE: Reaction as Russell wins but Piastri and Norris collide in Canada - racingnews365.com
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is where the MOV conducts again, and dissipated the energy.
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
(Dc diagram shown, AC is similar).
[old diagram got deleted by accident]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
One is “what exactly is in a ‘surge protector’ ? ”
It seems Mohan does not understand the difference between a comment and an Answer.
NASA robot for drilling on icy moons tested on Alaskan glacier - Ars Technica
The other is “what does a “fuse” do?”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The third is lightning and “how it gets conducted into a home.”
Roberts: Chance Of Ohtani Pitching Before All-Star Break Is "North Of Zero" - MLB Trade Rumors
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
First Sentence:
At least they know the answer if they wanted it.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
so, what happens?
Now when you have a certain ac resistance, then a current flows in a loop.
what exactly is a ‘surge’ protector?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
It also is a device that limits the change in current flow.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This device then solves the entire problem.
but I think this circuit , shows a few more pieces.
What does a fuse do?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Because the load is inductive, the current lags the voltage.(by a bit).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Barnstars:
a photo is worth a thousand words.
He then describes the function of a fuse.
What is lightning?
In schematic diagrams this is the symbol for a fuse:
the problem then depends on "how fast does the fuse operate?".
2024–10–10[John johnson John Johnson ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is 'the assistant's answer'
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
An AC voltage/ current source, and an ac inductive load.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
A circuit breaker is similar, but is resettable.
Upvotes:
Here is a simplified AC power diagram.
but this device (an Inductor) … impedes the rapid changes in the current.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There are three different concepts here that are getting confused.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
He then describes Rainy Season and Lightning.
He then asserts :